beautypg.com

Underfloor products iom, Replacement parts list, Primary air damper – Titus UnderFloor Products IOM User Manual

Page 7

background image

7

Installation Manual - Underfloor Products

Underfloor Products IOM

Redefine your comfort zone. ™ | www.titus-hvac.com

Description

Part Number

Multipoint Velocity Sensors
Size

9”

3151520005

Size

10”

3151520006

Damper Shaft Bearing
Shaft Bearing – All

70324901

Primary Damper Assembly (LHK)
Size

9

31171304

Size

10

31171305

Description

Part Number

Plugs for Tees
.25”

42160081

.38”

10015601

Fan Motor Fuse (SC-CL-G 300V)

1 Amp

10048301

3 Amp

10048501

4 Amp

10048601

6 Amp

10048801

8 Amp

10049001

10

Amp

10049101

12

Amp

10049201

15

Amp

10049301

20

Amp

10105201


Disconnects

Fan Toggle (All)

10027801

Door Interlock 3P/40A (All)

10053201

Door Knob 40 Amp

100532011

Door Interlock 3P/80A (All)

10054601

Door Knob 80 Amp

100546011

Unit Size

Filter Size

Part Num-

ber
Induced Air Filters
Model LHK
3

18 x 10

1026491810

4

18 x 14

1026491814

Model PFC
10

18 x 10

1026491810

14

16 x 14

1026491614

16

14 x 16

1026491614

Control Tube

Red Stripe .25” O.D.

61510035

Green Stripe .25” O.D. 61510034

Red Stripe .38” O.D.

61510279

Green Stripe .38” O.D. 61510280

Tees for Sensor Taps
Plastic

.25”

42150011

Plastic

.38”

42150020

Replacement Parts List

LHK Model:
To replace the damper blade and/or shaft assemblies:
a. Disconnect power before servicing. Remove control enclosure cover

to access actuator.

b. Note position of damper shaft, using indicating arrow. Loosen

linkage or actuator collar to allow damper to rotate freely.

c. Remove bottom access door to expose damper assembly. Rotate

damper to fully closed position, exposing rivets holding damper

blade to shafts.

d. Drill out rivets using 1/2” drill, rotate damper to fully open position,

and slide damper and/or shaft assemblies out of the duct.

e. Fit new damper and/or shaft assemblies in place, using 1/4-20

screws with lock nuts to replace rivets.

f. Reverse procedure in steps c, b, and a, for assembly. When locking

down actuator linkage or collar, position indicating arrow on damper

in the same location as before the repair.

Replacement Parts List

Primary Air Damper