Titus RadiaTec IOM - Manual (Page 6)

Surface Mount Installation
Page 6
RadiaTec Diffusers
Figure 8
Figure 9
STEP 4. Open the diffuser face by loosening all ¼-turn fasteners. Figure 8 shows the
face screen in the secured position and Figure 9 shows the face screen
opened and a new filter being inserted.
Note: The diffuser face must be supported when this occurs, as the face will
swing open and hang by the retainer cables.
STEP 5. Install hanging wires through the holes in the diffuser frame and
tighten the wires. See Figure 1.
STEP 6. Use the self-tapping screws supplied to attach the back pan flange to the back
pan installation brackets. This can be done from the room-side. Figure
10 shows self-tapping screw locations.
STEP 7. Restore diffuser face and lock all ¼-turn fasteners. Figure 8 shows the location
of ¼-turn fasteners.
(Continued)
Figure 10