Titus RadiaTec IOM - Manual (Page 3)

RadiaTec Diffusers
Page 3
The diffuser face can be assembled to the back pan prior to installation. Due to the weight of
the diffuser, the Titus RadiaTec was designed for assembly in the ceiling, if necessary. To
assemble the diffuser in the ceiling, use the following steps:
Lay-In Ceiling Grid Installation
STEP 1. Lay the diffuser face on the T-bar. See Figure 1 for major installation
components.
STEP 2. Install hanging wires through the holes in the diffuser frame and tighten the
wires. See Figure 1.
STEP 3. Lay the back pan on the diffuser frame using an adjacent open ceiling panel
as shown in Figure 2.
STEP 4. Use the self-tapping screws provided to fasten the back pan flange to the
installation brackets on the diffuser face. Figure 3 shows the self-
tapping screws.
STEP 5. Attach the duct to the back pan.
Figure 1
Figure 2 Figure 3
(Continued)