Regency Liberty L390EB Medium Gas Insert - Manual (Page 49)

L390E-2 / HZI390E-2 Direct Vent Gas Insert
49
Maintenance
l390e /l390eB ceraMic Burner reMOVal / installatiOn
3) Lift the Burner slightly while pulling forward to clear the mixing tube.
4) To install - reverse Steps 3-2, see Step 1 for correct installation tips.
1) Remove left/right filler sections - see below.
Discard fillers only if inner panels are being installed.
2) Remove burner by removing left and right screws off the burner bracket.
Left /right filler sections.
Burner Mounting
Bracket Right
Burner Mounting
Bracket Left
Mixing Tube
Support
Gas Orfice
Pilot Assembly
Air
Shutter
Firebox
Front View
care must be taken when installing the burner into the firebox.
Do not damage, knock or scrape the pilot assembly.
the flame sensor and ignition lead are fragile and can be damaged
easily.
*Satin black paint is included if touch ups are required.
important note:
A correctly installed burner - the burner is back far enough,
lower the front edge so that the front flange of the burner
(underneath) sits down into the grooves in the burner mount-
ing brackets Left and Right. There will be a small gap between
the Ceramic Burner and the firebox Bottom Flange. The Burner
should be situated about ¼” (6mm) inside the front edge of the
firebox.
installatiOn reMOVal
6mm