Regency Excalibur EX90 Large Wood Fireplace (Canadian Edition) - Manual (Page 23)

FPI FP90 Wood Fireplace 23
INST
ALLA
TION
fan installation
01/13/11 918-437
FP90
FAN INSTALLATION
NOTE: If optional Ashtray is installed, it must be removed before installing the fan.
The receptacle Box must be wired for the fan cable to be plugged into.
1) Remove the thumb screw from the fan transfer tray.
2) Slide fan transfer tray fully out through the bottom louver opening.
3) Mount the fan bracket onto the fan transfer tray using the two locating pins.
4) Slide the Control Box onto the Control Box Mounting Bracket located on the front of the fan transfer tray and secure with
the #8 x 3/8” screw provided (refer to Diagram 1).
5) Install the wiring as shown on the wiring diagram. Use the strength relief for running the wires from the fan transfer tray to
the receptacle box or the ground screw (refer to Diagram 2).
6) Slide the fan transfer tray back into the unit and hook up wires to the Control Box.
GROUND
Green
GROUND
[Green]
FAN
NEUTRAL - FROM FAN [Black]
[Black]
[Black]
[Black] [Black]
[Black]
[Black]
[White]
[White]
Note: Red wire not used.
Diagram 1
Fan transfer tray
Thumb Screw
Control Box
mounting bracket
Control
Box
Locating Pins
installation