STEMCO Axle Pro - Manual (Page 9)

Axle Pro Equipment Instruction Guide
For your protection, use Standard Shop Safety Procedures during this process
Page 9 of 24 01 577 0092 SEPT 2011
Step 2: Pre-Drill Cutter and Reamer Setup
a. Attach extension fitting and cutter to drill using
allen wrenches.
Critical step must attach the 2 inch extension.
(Photo 2A)
b. First time use, reamer must be mounted to arbor.
Place reamer over arbor, interlocking reamer
taper against arbor taper and aligning notches.
(Photo 2B)
Firmly strike small end of arbor against surface to assure proper taper interlock.
After assuring proper taper interlock, thread nut
and collar towards reamer, finger tight only. If
reamer ever needs to be removed use wrench on
nut, threading towards reamer. (Photo 2C)
Photo 2A
Photo 2B
Photo 2C