STEMCO 821-7001 BatRF Tractor Interface Module - Manual (Page 9)

Certifications
FCC (USA)
This unit complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
FCC ID: SRA-821
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
„ „ Reorient or relocate the receiving antenna.
„ „ Increase the separation between the equipment and receiver.
„ „ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
„ „ Consult the dealer or an experienced radio/TV technician for help.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this
equipment. Such modifications could void the user’s authority to operate the equipment.
The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons
and must not be co-located or operating in conjunction with any other antenna or transmitter. Users and installers must be
provided with antenna installation instructions and transmitter operating conditions for satisfying Rf exposure compliance.
Should you need any additional assistance with any problems or issues please contact STEMCO Customer Service at (800)
527-8492.
Industry Canada
Contains/Contient IC: 7413A-821
NOTICE: This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Avis: Cet appareil est conforme avec Industrie Canada RSS standard exempts de licence (s). Son fonctionnement est soumis
aux deux conditions suivantes: (1) cet appareil ne peut pas provoquer d’interférences et (2) cet appareil doit accepter toute
interférence, y compris les interférences qui peuvent causer un mauvais fonctionnement du dispositif.
This document may be referenced by STEMCO Part# 09-930-8210
an EnPro Industries company
STEMCO - USA
P.O. Box 1989
Longview, TX 75606-1989
(903) 758-9981 • 1800-527-8492
FAX: 1-800-874-4297
www.stemco.com
STEMCO - CANADA
5650 Timberlea Blvd. Unit B
Mississauga, ON L4W 4M6
(905) 206-9922 • 877-232-9111
FAX: 877-244-4555
STEMCO, BAT RF, HandBAT,
AirBAT and TracBAT are
trademarks of STEMCO LP
© 2014 STEMCO LP
PN# 09-930-8210 - 06/14