STEMCO 821-7001 BatRF Tractor Interface Module - Manual (Page 6)

Tractor Interface Module Installation Guide 4
821-7000 – RS232 Cable
ONLY Instructions
5a. Classic - From the main menu
select “Main” and use the down
arrow to scroll through the menu
options to the bottom of the list.
Select “OBC Administration” from
the main menu.
Tablet/BLU - From the “Home”
screen select “System” (top right)
and then “OBC Diagnostics”;
scroll down in the list box and
select “OBC Administration”
5b. ALL - Using the keyboard enter
the password, “9238” and
press “Enter”.
5c. Classic - Select “Serial Port Config”.
Tablet/BLU - Scroll down in the
list box and select “Serial Port
Configuration”
5d. ALL - Select “g3 Services”.
This will assign the serial port to
be used by g3 Services.
5e. ALL - Press the down arrow
several times to select a baud
rate of “57600”
5f. ALL - Select “OK” to reset the
OBC and to finish the port
configuration. Wait for the OBC
to reboot (Classis ~15 seconds;
Tablet/BLU ~2 minutes).
5a
5a
5c
5d
5f
5c
5d
5e
5f
5b
Classic LCD Display Tablet BLU & BLU II