Brother DCP-560CN - Manual (Page 80)

72
Changing LCD language
B
You can change the LCD language.
a
Press Menu.
b
Press a or b to choose
Initial Setup
.
Press OK.
c
Press a or b to choose
Local Language
.
Press OK.
d
Press a or b to choose your language.
Press OK.
e
Press Stop/Exit.
Error animation
B
Error animation displays step-by-step
instructions when paper gets jammed or ink
cartridges become empty. You can read the
steps at your own pace by pressing c to see
the next step and d to go backward. If you do
not press a key, after 1 minute the animation
starts running automatically again.
Note
You can press c, d or OK to pause the
auto-animation and go back to step-by-
step mode.
Document jam
(DCP-560CN only)
B
Documents can jam in the ADF unit if they are not
inserted or fed properly, or if they are too long.
Follow the steps below to clear a document jam.
Document is jammed in the top of the
ADF unit
B
a
Take out any paper from the ADF that is
not jammed.
b
Open the ADF cover.
c
Pull the jammed document up and to the left.
d
Close the ADF cover.
e
Press Stop/Exit.
Note
To avoid future document jams close the
ADF cover properly by pushing it gently in
the middle.
Unusable Device
Disconnect device from
front connector & turn
machine off & then on
A broken device has been
connected to the USB direct
interface. Unplug the device from the USB direct
interface, then press On/Off to turn the
machine off and then on again.
Unusable Device Please
Disconnect USB Device.
A USB device or USB Flash
memory drive that is not
supported has been connected
to the USB direct interface.
For more information, visit us at
http://solutions.brother.com. Unplug the device from the USB direct
interface.
Error Message Cause Action