Sensaphone WEB600 Users manual User Manual

Page 16

WEB600 User’s Manual

Configuration page

Network Configuration using a Static IP Address:
If your network does not support DHCP then your Web600 will set its IP address to 192.168.1.250. This

address should only be temporarily set. Leaving this address as the factory default could result in net-

working conflicts if another Web600 is added to your network.
If your network does not support DHCP then you will have to use one of the following methods to

change the IP of the Web600 for the first time.
1) Using a standard RJ45 crossover cable (not included) connect your PC’s network jack to the Web600

temporarily. Change the IP of your computer’s network connection to something in 192.168.1.xxx that is

not the same as the default IP of the Web600.
After navigating to the network configuration page, you should now be able to access the network con-

figurations of your Web600, and set them accordingly.
NOTE: It is highly recommended that you consult all network configurations and settings changes with

your Network Administrator.
2) Using a network hub connect only your PC and the Web600 to the hub. Change the IP of your net-

work connection to something in 192.168.1.xxx that is not the same as the default IP of the Web600.

After navigating to the network configuration page, you should now be able to access the network con-

figurations of your Web600 and set them accordingly.
NOTE: It is highly recommended that you consult all network configurations and settings changes with

your Network Administrator.
3) Using a network router that is configured for DHCP server connect both your Web600 and your

computer to the router. Power cycle your Web600. Configure your computer’s network connection for

using DHCP. Once the Web600 has rebooted it should have acquired an IP from the router’s DHCP

server. Log into your router and see what IP the router gave to the Web600. After navigating to the net-

work configuration page, you should now be able to access the network configurations of your Web600

and set them accordingly.