Sensaphone WEB600 Users manual - Manual (Page 11)

11
Chapter 1: installation
InsTallaTIon
This section provides information on:
• Operating environment
• Installation
• Connecting sensors/Battery backup module
• Network Configuration
parts reqUired
• Phillips Screwdriver
• Cat 5 Patch Cable
• Network Hub, Switch, or Router that supports 10 or 100 BASE-T
• Computer w/Network Connection
operatinG enVironMent
Before you install the Web600 be sure that your operating environment meets the physical requirements
of the equipment.
Operating Temperature: 32º–122º Fahrenheit (0º–50º C)
Humidity:
5–90 %RH, non-condensing
Power: 115VAC 60 Hz outlet within 6’
wall MoUnt installation
The Web600 can be wall mounted using the included dry wall anchors and screws. Follow the steps
below:
1) Install two drywall anchors (if necessary) 5” apart. Attach the Web600 using the two #6 tapping
screws.
2) Attach sensors to the zone terminals.
3) Plug the power adaptor into a 115VAC 60Hz outlet.
4) Connect a CAT5 cable to the Ethernet port and connect to a 10/100 network hub, switch or router.
tabletop installation
The Web600 can be installed on a tabletop or shelf. Follow the steps below:
1) Attach the four self-adhesive rubber feet to the four corners on the bottom of the Web600.
2) Place the unit on a tabletop or shelf.
3) Attach sensors to the input terminals.
4) Plug the power adaptor into a 115VAC 60Hz outlet.
5) Connect a CAT5 cable to the Ethernet port and connect to a 10/100 network hub, switch or router.