beautypg.com

SATEC PM180 Installation Manual User Manual

Page 2

background image

PM180 Substation Automation Unit

i

LIMITED WARRANTY

The manufacturer offers the customer a 24-month functional warranty on the instrument for faulty workmanship or
parts from date of dispatch from the distributor. In all cases, this warranty is valid for 36 months from the date of
production. This warranty is on a return to factory basis.

The manufacturer does not accept liability for any damage caused by instrument malfunction. The manufacturer
accepts no responsibility for the suitability of the instrument to the application for which it was purchased.

Failure to install, set up or operate the instrument according to the instructions herein will void the warranty.

Your instrument may be opened only by a duly authorized representative of the manufacturer. The unit should
only be opened in a fully anti-static environment. Failure to do so may damage the electronic components and will
void the warranty.

NOTE

The greatest care has been taken to manufacture and calibrate your instrument. However, these instructions do
not cover all possible contingencies that may arise during installation, operation or maintenance, and all details
and variations of this equipment are not covered by these instructions.

For additional information regarding installation, operation or maintenance of this instrument, contact the
manufacturer or your local representative or distributor.

I

I

IM

M

MP

P

P O

O

O R

R

R T

T

T A

A

AN

N

N T

T

T

Please read the instructions in this manual before performing installation, and take note of the following
precautions:

1. Ensure that all incoming AC power and other power sources are turned OFF before performing any work
on the instrument. Failure to do so may result in serious or even fatal injury and/or equipment damage.

2. Before connecting the instrument to the power source, check the labels on the side of the instrument to
ensure that your instrument is equipped with the appropriate power supply voltage, input voltages, currents,
analog output and communication protocol for your application

3. Do not connect the instrument to a power source if it is damaged.

4. Do not expose the instrument to rain or moisture.

5. The secondary of an external current transformer must never be allowed to be open circuit when the
primary is energized. An open circuit can cause high voltages, possibly resulting in equipment damage, fire and
even serious or fatal injury. Ensure that the current transformer wiring is made through shorting switches and is
secured using an external strain relief to reduce mechanical strain on the screw terminals, if necessary.

6. Setup procedures must be performed only by qualified personnel familiar with the instrument and its
associated electrical equipment

7. Do NOT open the instrument under any circumstances.

Read this manual thoroughly before connecting the meter to the current carrying circuits.

During operation of the meter, hazardous voltages are present on input terminals. Failure
to observe precautions can result in serious or even fatal injury or damage to equipment.

All trademarks are property of their respective owners.

June 2013

Copyright 2003-2013  SATEC Ltd.