Brother DCP 8065DN - Manual (Page 103)

Appendix A
91
A
UNIX ® /Linux systems
Typically, UNIX ® and Linux systems require the colon ":" character between each digit of the Ethernet
address.
arp -s 192.168.1.2 00:80:77:31:01:07
Note
You must be on the same Ethernet segment (that is, there cannot be a router between the print server and
operating system) to use the arp -s command.
If there is a router, you may use BOOTP or other methods described in this chapter to enter the IP address.
If your Administrator has configured the system to deliver IP addresses using BOOTP, DHCP or RARP your
Brother print server can receive an IP address from any one of these IP address allocation systems. In which
case, you will not need to use the ARP command. The ARP command only works once. For security reasons,
once you have successfully configured the IP address of a Brother print server using the ARP command, you
cannot use the ARP command again to change the address. The print server will ignore any attempts to do
this. If you wish to change the IP address again, use a web browser, TELNET (using the SET IP ADDRESS
command) or factory reset the print server (which will then allow you to use the ARP command again).
To configure the print server and to verify the connection, enter the following command ping ipaddress
where ipaddress is the IP address of the print server. For example, ping 192.189.207.2.
Using the TELNET console to configure the IP address
You can also use the TELNET command to change the IP address.
Using TELNET is effective way, when you change the IP address. But a valid IP address must already be
programmed into the print server.
Type TELNET ipaddress at the command prompt of the system prompt, where ipaddress is the IP address
of the print server. When you are connected, push the Return or Enter key to get the “#” prompt, enter the
password "“access”" (the password will not appear on the screen).
You will be prompted for a user name. Enter anything in response to this prompt.
You will then get the Local> prompt. Type SET IP ADDRESS ipaddress, where ipaddress is the
desired IP address you wish to assign to the print server (check with your network manager for the IP address
to use). For example:
Local> SET IP ADDRESS 192.168.1.3
You will now need to set the subnet mask by typing SET IP SUBNET subnet mask, where subnet mask
is the desired subnet mask you wish to assign to the print server (check with your network manager for the
subnet mask to use). For example: