Orbit Baby G3 Infant Car Seat and Base - Manual (Page 45)

Maintaining Y
our Car Seat
Maintaining Y
our Car Seat
89
89
88
88 88
To clean the upholstery:
1. Machine wash in cold water on a
gentle cycle with a mild detergent,
such as Orbit Baby’s Upholstery Wash.
Washing inside a pillow case and in a
front-loading washer is recommended.
DO NOT USE BLEACH.
2. Lay the upholstery flat to dry. Do not
machine dry. Machine drying may
cause excessive shrinkage and result
in the upholstery not fitting the car seat
properly.
3. Re-install the upholstery once cleaned
and completely dried. DO NOT use the
car seat without the upholstery.
To clean the sunshade:
1. The sunshade may be spot cleaned
with Orbit Baby’s Spot Treatment or a
damp sponge and mild soap. Do not
machine wash or dry the sunshade.
Cleaning the Upholstery
and Sunshade
Re-installing the Upholstery
and Sunshade
C
B
A
To re-install the upholstery:
1. Ensure that the chest clip and crotch
buckle are unbuckled. Position the
upholstery within the car seat.
2. Thread each side of the restraint
harness through the hook and loop
opening in the center panel of the
upholstery.
3. CHECK that the shoulder straps are
threaded thought slots in the upholstery
and seat shell that are at the same
height (Photo A).
4. Thread the lap portions of the straps
through the slots at the sides of the
bottom of the center panel (Photo B).
5. Pull the crotch buckle through the outer
slot in the upholstery (Photo C). If using
the foam insert from the Orbit Baby
Lower Birth Weight Fit Kit, use the inner