Warning – Orbit Baby G3 Infant Car Seat and Base User Manual

Page 15

Usage Recommendations

The following diagrams show how to properly install and remove the LATCH/
UAS connectors included on the car seat base.

Lower LATCH/UAS
anchorages identified
by this symbol

Seat Bight

LATCH/UAS connectors must be secured to the vehicle
LATCH/UAS anchorages only. Connections to other vehicle
components could result in an unsafe installation of the car seat.

⚠WARNING⚠

Death or Serious Injury Can Occur

To Secure:

• Slide LATCH/UAS connector completely onto the

vehicle LATCH/UAS anchorage. You should hear a
CLICK when the connector locks onto the LATCH/
UAS anchorage.

• Check that the LATCH/UAS connector is locked

onto the vehicle LATCH/UAS anchorage by pulling
out on it.

To Remove:

• Press and hold the red release button on the

LATCH/UAS connector.

• Slide LATCH/UAS connector off the LATCH/UAS

anchorage.

Installing with the LATCH/UAS Anchorage System

cont’d

Only install the car seat base with LATCH/UAS if using a vehicle seating location
that is recommended by the vehicle manufacturer. In addition, rear-center
seating locations in the United States may be used if the center-to-center
LATCH/UAS anchorage spacing is between 280mm and 500mm (11 and 20
inches) and this use is approved by the vehicle manufacturer. In Canada, the
nominal spacing on all approved UAS anchorages is 280mm.