Orbit Baby G3 Infant Car Seat and Base - Manual (Page 35)

68
68
Securing Y
our Child
Securing Y
our Child
69
69
tongue is inserted into the buckle.
7. Pull up on the buckle tongues to
CHECK they are locked. DO NOT use
the car seat if the restraint harness
does not lock in place, and contact
Orbit Baby.
8. Gently pull up on the shoulder straps to
tighten the lap section of the restraint
harness (Photo E).
9. CLICK the chest clip pieces together
and position the chest clip at armpit
level, as shown (Photo F).
10. Slowly pull the adjuster strap to snugly
adjust the restraint harness onto the
child (Photo G).
11. CHECK again that the restraint harness
is not twisted (Photo C).
12. CHECK that the restraint harness
is snug on shoulder and thighs. Do
not allow more than one finger to
Securing Your Child with the Restraint
Harness
cont’d
E
F
G D
C
B
Buckling the restraint harness:
1. Unbuckle the restraint harness by
squeezing the tabs on the chest clip as
shown (Photo A).
2. Unbuckle both buckle tongues by
pushing the red button on the crotch
buckle (Photo B).
3. Place your child into the car seat,
making sure both the child’s back
and bottom are fully supported by the
seating surfaces.
4. Position the restraint harness around
the child’s shoulders and thighs. The
crotch pad should be between the child
and the crotch buckle.
5. CHECK that there are no twists in the
restraint harness straps (Photo C).
6. Insert both buckle tongues into the
crotch buckle (Photo D). You should
hear and feel a
CLICK as each buckle