Warning, Gf e d – Orbit Baby G3 Infant Car Seat and Base User Manual

Page 27

Installing the Car Seat Base and Car Seat

⚠WARNING⚠

Death or Serious Injury Can Occur

The car seat must always be
locked in the car seat base in
the rear-facing position when
the vehicle is in motion.

Docking the Car Seat on the Car Seat Base

cont’d

the car seat into the SmartHub of the
car seat base until you hear and feel a
CLICK

(Photo C).

For increased comfort and ease of
use, the car seat can be docked onto
the car seat base from almost any
angle.

3. Once the car seat is locked into the

SmartHub, rotate the car seat until you
hear and feel another

CLICK as it locks

into the rear-facing position. The car
seat will only lock when rotated into the
rear-facing position (Photo D). Note
that it will only lock when the release
levers are not pulled.

CHECK that the car seat is locked into

rear-facing position by looking at the
rotation indicators on either side of the
car seat base (Photo E). If they show
red (Photo F), the car seat is not locked
rear-facing. Re-dock the car seat.

NOTE: A small amount of rotational
movement is normal, but the car seat
should not rotate out of rear-facing
position and the rotation indicators
should not be showing red.

If the rotation indicators show red with

every docking attempt, do not use the
car seat or car seat base, and contact
Orbit Baby.

RECHECK that the car seat is locked

into the rear-facing position by pushing
down firmly on both sides of the car
seat and pulling in several directions
(Photo G) to be certain it is locked. It
should not rotate out of the rear-facing
position. If it does, do not use the car
seat and contact Orbit Baby.