Orbit Baby G3 Infant Car Seat and Base - Manual (Page 19)

Installing the Car Seat Base and Car Seat
Installing the Car Seat Base and Car Seat
37
37
36
36
37
37
1. With LATCH/UAS:
See Installing the
Car Seat Base: With
LATCH/UAS.
2. With lap-shoulder
vehicle belt:
See Installing the Car
Seat Base: With Vehicle
Seat Belt.
3. With vehicle lap belt:
See Installing the Car
Seat Base: With Vehicle
Seat Belt.
Installing the Car Seat Base: Overview
If you are installing the car seat with the car seat base, first install the car seat
base, and then dock the car seat on the car seat base. The car seat base can
be installed using either LATCH/UAS, or a vehicle seat belt.
Installing the Car Seat Base:
With LATCH/UAS
Before you install the car seat base in your
vehicle, make sure the vehicle is parked on
level ground.
1. The car seat base should be installed
without the car seat attached (Photo A).
Follow instructions in the Rotating and
Removing the Car Seat from the Car
Seat Base to remove the car seat from
the car seat base.
2. CHECK that the car seat base StrongArm
is set to zero (Photo B). If not, turn the
StrongArm knob counterclockwise until
the zero line is visible.
3. Remove the LATCH/UAS connectors
from their storage locations by
pressing the red buttons and pulling
the connectors upward (Photo C). For
ease of installation, extend the LATCH/
UAS belt to its maximum length by
pressing the grey button on the belt
adjuster and pulling on the belt.
4. Position the LATCH/UAS belt through the
belt guides as shown (Photo D). The logo
on the LATCH/UAS connectors should
A
B
C