Orbit Baby G3 Infant Car Seat and Base - Manual (Page 25)

Installing the Car Seat Base and Car Seat
Installing the Car Seat Base and Car Seat
49
49
48
48
49
49
48
48
22. RE-CHECK the following to make sure
that the car seat base installation is
secure:
a. CHECK that the car seat base
installation is not loose. It should
not move by more than 2.5 cm (1 in)
in any direction.
b. CHECK that the car seat base is
level by making sure that window in
the level indicator is green (Photo P).
If the car seat base is loose or if the
level indicator window shows red
(Photo Q), remove and re-install the car
seat base beginning at Step 2.
23. Lap-shoulder vehicle belt systems in
some vehicles have an Auto Locking
Mode which locks the shoulder portion
of the belt and keeps it from becoming
a hazard to older children or siblings.
To engage this mode (which we
recommend), pull the shoulder portion
of the belt out completely from the
vehicle, then let go. You should hear
a soft clicking sound as you allow the
belt to retract back into the vehicle.
Installing the Base: With Vehicle Seat Belt
cont’d
To un-install the car seat base and
remove it from your vehicle:
1. Turn the StrongArm knob
counterclockwise and reset the car seat
base StrongArm to zero (Photo A).
2. Open the lock-off clamp (Photo B),
unbuckle the vehicle seat belt and
guide it back through the belt guides
(Photo C).
3. Using both hands to support the weight
of the car seat base, remove it carefully
from the vehicle.
C
B
A
Q
P
Un-installing the Car Seat Base:
With Vehicle Seat Belt