Orbit Baby G3 Infant Car Seat and Base - Manual (Page 22)

Installing the Car Seat Base and Car Seat
Installing the Car Seat Base and Car Seat
43
43
42
42
43
43
42
42
A
B
C C
B
A
To un-install the car seat base and
remove it from your vehicle:
1. Turn the StrongArm knob
counterclockwise and reset the car seat
base StrongArm to zero (Photo A).
2. Push and hold the red button on each
LATCH/UAS connector and pull it off
the vehicle LATCH/UAS anchorage
(Photo B). Store the LATCH/UAS
connectors as shown (Photo C).
3. Using both hands to support the weight
of the base, remove it carefully from the
vehicle.
Un-installing the Car Seat Base:
With LATCH/UAS
Installing the Base:
With Vehicle Seat Belt
Before you install the car seat base in your
vehicle, make sure the vehicle is parked on
level ground.
1. The car seat base should be installed
without the car seat attached (Photo A).
Follow instructions in the Rotating and
Removing the Car Seat from the Car
Seat Base to remove the car seat from
the car seat base.
2. CHECK that the car seat base
StrongArm is set to zero (Photo
B). If not, turn the StrongArm knob
counterclockwise until the zero line is
visible.
3. If the LATCH/UAS belt is routed
through the belt guides, remove
from belt guides. (Note: The belt is
permanently routed behind the lock-
off clamp). Store the LATCH/UAS
connectors in their storage location
when they are not in use (Photo C).
Each connector will click securely into
its own storage slot.
4. If the vehicle seat back is adjustable,