Opticon PX 20 v37938 Batch demo Quick Guide - Manual (Page 5)

5
3 Customizing your barcode terminal
In the following section a brief overview is given on how to configure your barcode reader for your desired
application.
3.1 Selecting the USB interface (VCP or MSD)
This batch demo application supports two methods of retrieving your barcode database file from the barcode
readers:

USB Mass Storage Device (MSD)

USB Virtual Com Port (USB-VCP) using OseComm or NetO32 to retrieve the file
After loading this software on your barcode reader for the first time, the barcode reader will automatically be reset
to use USB-VCP by default.
If you would like to use your barcode reader as a USB-MSD device, read the label below.
(The labels below can be read without reading any SET/END labels)
USB-MSD default
More information on how to use your barcode reader as a USB-MSD device will be given in chapter 8.
To switch back to USB-VCP default (to load software, for example) read the label below.
USB-VCP default
More information on how to use your barcode reader with USB-VCP and OseComm32/NetO32 will be given in
Chapter 9.