Opticon OPL 7736 brief setup - Manual (Page 2)

2 - OPTICON
Overview of steps
Depending on the type of device to be connected,
take the steps as further described. To configure
the required options:
• scan the SET label
• scan the required option(s)
• scan the END label
After scanning the END label, the new settings are
stored in non volatile memory.
Reader to Cradle
• connect by scanning (step 3 A )
PC to reader
• discover & connect (step 3 B)
Reader to PC / Other device
• retrieve device address (step 1)
• connect mode (step 2)
• security options (step 2 Optional)
• connect by scanning (step 3 A)
To disconnect the current reader:
• scan the disconnect label (step disconnect)
To return to default settings:
• scan the reset label (step reset)
---------------------------------------------------------------
[STEP 1]
– RETRIEVE ADDRESS
The address is mostly displayed on the product
label as a hexadecimal code (example: 00-11-F6-
03-39-69). Otherwise consult the documentation of
the device how to retrieve the device address code.
To enable the reader to communicate to the other
device, the reader must be configured with this
code. The easiest way to do this is to create a
barcode label of the hexadecimal code as
described below.
– CREATE LABEL
Opticon provides a simple on-line application on
http://opticonfigure.opticon.com/bluetooth.asp or
http://opticonfigure.opticon.com/ieee.asp
• Type in the digits of the hexadecimal code in
numbers and capital characters without dashes,
dots and spaces (example: 0011F6033969).
• Submit the code into a barcode (example:
0011F6033969 ). You have to print the screen
to have it available for scanning.
---------------------------------------------------------------
[STEP 2]
CONNECT MODE
---------------------------------------------------------------
SET _ZZ_ ZZ
Connect to
PC _CNPC_ CNPC
END _ZZ_ ZZ