Omnitron Systems Technology FlexSwitch 6750 FK User Manual
Page 6
•
Prepare a power cable using a three conductor insulated wire (not supplied)
with a 14 AWG gauge minimum. Cut the power cable to the length required.
•
Strip approximately 3/8 of an inch of insulation from the power cable
wires.
•
Connect the power cables to the iConverter Chassis by fastening the
stripped ends to the DC power connector.
WARNING: Note the wire colors used in making the positive, negative
and ground connections. Use the same color assignment for the connection
at the circuit breaker.
•
Connect the power wires to the circuit breaker and switch the circuit breaker
ON. If any modules are installed, their Power LED should indicate the
presence of power.
Rear of 2-Module Chassis with DC Power Connector
NEVER ATTEMPT TO OPEN THE CHASSIS OR SERVICE THE
POWER SUPPLY OR FAN MODULE. OPENING THE CHASSIS
MAY CAUSE SERIOUS INJURY OR DEATH.
THERE ARE NO USER REPLACEABLE OR SERVICEABLE
PARTS IN THIS UNIT.
WARNING!!!
Page 6
- iConverter 2GXT Standalone (2 pages)
- iConverter GX/T2 Plug-in Module (2 pages)
- iConverter GX/T2 Standalone Module (2 pages)
- iConverter 2-Port SFP to SFP GM4 (2 pages)
- iConverter 3-Port GM4 (2 pages)
- iConverter 2-Port GM4 (2 pages)
- iConverter 4GT Plug-in Module (2 pages)
- iConverter 4GT Standalone Module (2 pages)
- iConverter Network Management Module (25 pages)
- iConverter Network Management Module (2 pages)
- iConverter 10/100M (47 pages)
- iConverter GXTM Standalone Quick Start (2 pages)
- iConverter GXTM Plug-in Module (2 pages)
- Converter GXTM User Manual (48 pages)
- iConverter 2FXM User Manual (46 pages)
- iConverter 2FXM Standalone Quick Start (2 pages)
- iConverter 1-Module Power Chassis (4 pages)
- iConverter 1 Module Redundant Power Chassis (26 pages)
- iConverter 2-Module Power Chassis (12 pages)
- iConverter T3/E3 Standalone Module (2 pages)
- iConverter T3/E3 Plugin Module (2 pages)
- iConverter 19-Module Chassis (10 pages)
- iConverter 5-Module Chassis (8 pages)
- iConverter RS422/485 (1 page)
- iConverter X21 Standalone Module (2 pages)
- iConverter X21 Plug-in Module (2 pages)
- iConverter RS232 (1 page)
- iConverter 4Tx VT (1 page)
- iConverter 4Tx (1 page)
- iConverter Tx/2Fx (1 page)
- iConverter T1/E1 Standalone Module (2 pages)
- iConverter T1/E1 Plugin Module (2 pages)
- iConverter STM 1 Standalone (2 pages)
- iConverter STM 1 Plug-In (2 pages)
- iConverter 2Fx (1 page)
- iConverter xFF Standalone Module (1 page)
- iConverter xFF Plugin Module (1 page)
- iConverter 2FXM2 Standalone Module (2 pages)
- iConverter 2FXM2 Plugin Module (2 pages)
- iConverter 2GXM2 Standalone Module (2 pages)
- iConverter 2GXM2 Plugin Module (2 pages)
- iConverter 100Fx/Tx (1 page)
- iConverter 10/100 (2 pages)
- iConverter 10/100M2 Standalone Module (2 pages)
- iConverter 10/100M2 Plugin Module (2 pages)