Str46spvg — operation, Warning – Multiquip STR46SPVG User Manual

Page 23

STR46SPVG • RIDE-ON POWER TROWEL — OPERATION AND PARTS MANUAL — REV. #2 (07/09/07) — PAGE 23

STR46SPVG — OPERATION

Figure 7. Blade Speed Control Foot Pedal

Turn ignition key fully clockwise and listen for engine to
start. Once engine has started release ignition key.

If the engine fails to start in this manner, consult the engine
owner's manual supplied with the trowel.

Test the safety kill switch by standing up briefly. The switch
under the seat should cause the engine to stop. If the kill
switch fails to shut down the engine. Turn off the engine
with the key switch and fix the safety kill switch. See
Troubleshooting Chart for possible problems.

Repeat this section a few times to get fully acquainted with
the engine starting procedure.

Let the engine idle for 3-5 minutes. If choke is applied,
push the choke to the open position as soon as the engine
will run smoothly.

Figure 8. Oil and Charge Indicator Lights

This

ride-on trowel

is equipped with a safety

"safety stop

switch"

. This switch is located beneath the seat assembly.

Remember the engine will not start unless an operator is
sitting in the operator’s seat. The weight of an operator
depresses an electrical switch which will allow the engine
to start.

Important Information Before You Start

The safety stop switch should be used to stop the engine
after every use. Doing this will verify the switch is working
properly thus providing safety for the operator. Remember
to turn the key to the “OFF” position after stopping the
machine. Not doing so will drain the battery.

The right foot pedal (Figure 7) controls blade and engine
speed. The position of the foot pedal determines the blade
speed. Slow blade speed is obtained by slightly depressing
the pedal. Maximum blade speed is obtained by fully
depressing the pedal.

NEVER disable or disconnect the "safety stop switch".
It is provided for the operator's safety and injury or death
may result if it is disabled, disconnected or improperly
maintained.

WARNING

CAUTION - Kill Switch

Keep your foot OFF the gas pedal. If the engine is cold,
adjust the choke but in all circumstances, start the engine
at idle (without touching gas pedal).

Insert the

ignition key

into the ignition switch .

Turn the ignition key clockwise to the (start) position. The

oil

and charge indicator lights (Figure 8) should be on.

Starting the Engine

With one foot on the ground and the other foot placed on
the trowel's platform, grab the frame near the seat and lift
yourself onto the trowel. Sit in the operator's seat and ensure
the control handles, foot pedal and control panel items can
be comfortably accessed.