Multiquip WSHE_A_SERIES - Manual (Page 34)

page 34 — WSHe/a vibraTory TruSS Screed • operaTion manual — rev. #0 (05/22/12)
OperatiOn
STarTing
1. Place the engine fuel lever to the on position.
(Figure 21).
Figure 21. Engine Fuel Lever (ON Position)
2. Place the choke lever (Figure 22) in the cloSed
position if starting a cold engine.
Figure 22. Engine Choke Lever (Closed)
cauTion
do noT attempt to operate this vibratory
screed until the Safety Information,
General Information, and Inspection
sections of this manual have been read
and thoroughly understood.
NOTICE
The cloSed position of the choke lever enriches
the fuel mixture for starting a cold engine. The open
position provides the correct fuel mixture for normal
operation after starting, and for restarting a warm
engine.
3. Place the choke lever (Figure 23) in the open position
if starting a warm engine or the temperature is warm.
Figure 23. Engine Choke Lever (Open)
4. Move the throttle lever halfway between the FaST and
SloW position (Figure 24) for starting.
Figure 24. Throttle Lever
5. Place the engine ON/OFF switch (Figure 25) in the
on position.
Figure 25. Engine ON/OFF Switch