Multiquip WSHE_A_SERIES - Manual (Page 32)

page 32 — WSHe/a vibraTory TruSS Screed • operaTion manual — rev. #0 (05/22/12)
aSSeMbly
connecTing THe end Handle and engine
Frame SecTionS
1. The end handle and engine truss frame sections are
pre-assembled. Simply connect one end of engine truss
frame as shown in Figure 19
2. Thread adapter onto top pipe of engine truss frame
section.
3. Align end handle section with engine truss frame
section. Use blade connector to mate the two sections.
4. Next, insert bolt and washer into adapter and tighten
securely.
5. Connect the free end of engine truss frame to the
adjoining truss frame by means of a turnbuckle and
drive shaft coupler.
Figure 19. Mating End Handle and Engine Sections
BOLT
WASHER
END HANDLE
ADAPTER
MOUNTING
HARDWARE
ENGINE SECTION
BLADE
CONNECTOR