Multiquip WSHE_A_SERIES - Manual (Page 12)

page 12 — WSHe/a vibraTory TruSS Screed • operaTion manual — rev. #0 (05/22/12)
„ alWayS make sure the trailer is equipped with a safety
chain.
„ alWayS properly attach trailer’s safety chains to towing
vehicle.
„ alWayS make sure the vehicle and trailer directional,
backup, brake and trailer lights are connected and
working properly.
„ DOT Requirements include the following:
• Connect and test electric brake operation.
• Secure portable power cables in cable tray with tie
wraps.
„ The maximum speed for highway towing is 55 MPH unless
posted otherwise. Recommended off-road towing is not to
exceed 15 MPH or less depending on type of terrain.
„ Avoid sudden stops and starts. This can cause skidding,
or jack-knifi ng. Smooth, gradual starts and stops will
improve towing.
„ Avoid sharp turns to prevent rolling.
„ Trailer should be adjusted to a level position at all times
when towing.
„ Raise and lock trailer wheel stand in up position when
towing.
„ Place chock blocks underneath wheel to prevent rolling
while parked.
„ Place support blocks underneath the trailer’s bumper to
prevent tipping while parked.
„ Use the trailer’s swivel jack to adjust the trailer height to
a level position while parked.
environmenTal SaFeTy/decommiSSioning
NOTICE
Decommissioning is a controlled process used to safely
retire a piece of equipment that is no longer serviceable.
If the equipment poses an unacceptable and unrepairable
safety risk due to wear or damage or is no longer cost
effective to maintain (beyond life-cycle reliability) and is to
be decommissioned (demolition and dismantlement),be
sure to follow rules below.
„ do noT pour waste or oil directly onto the ground, down
a drain or into any water source.
„ Contact your country's Department of
Public Works or recycling agency in your
area and arrange for proper disposal of
any electrical components, waste or oil
associated with this equipment.
„ When the life cycle of this equipment is over, it is
recommended that the screed frame and all other metal
parts be sent to a recycling center.
Metal recycling involves the collection of metal from
discarded products and its transformation into raw
materials to use in manufacturing a new product.
Recyclers and manufacturers alike promote the process
of recycling metal. Using a metal recycling center
promotes energy cost savings.
NOTICE
The gasoline engine used in this equipment has been
designed to reduce harmful levels of carbon monoxide
(CO), hydrocarbons (HC) and nitrogen oxides (NOx)
contained in diesel exhaust emissions.
This engine has been certifi ed to meet US EPA Evaporative
emissions requirements in the installed confi guration.
Attempting to modify or make adjustments to the engine
emission system by unauthorized personnel without proper
training could damage the equipment or create an unsafe
condition.
Additionally, modifying the fuel system may adversely affect
evaporative emissions, resulting in fi nes or other penalties.
emission control label
The emission control label is an integral part of the emission
system and is strictly controlled by regulations.
The label must remain with the engine for its entire life.
If a replacement emission label is needed, please contact
your authorized Honda Engine Distributor.
Safety infOrMatiOn