beautypg.com

Basic engine – Multiquip MVH150VD2 User Manual

Page 15

background image

MVH150VD2 PLATE COMPACTOR • OPERATION AND PARTS MANUAL — REV. #0 (10/10/08) — PAGE 15

1

2

10

5

3

4

8

7

6

9

11

BASIC ENGINE

Compactor Components

Figure 3.

Figure 3 shows the basic Yanmar engine. The engine must
be checked for proper lubrication and fi lled with fuel prior to
operation. Refer to the manufacturer’s engine manual for
instructions and details of operation and servicing. Each
component is described below:

Fuel Filler Cap

1.

— Remove this cap to add unleaded

gasoline to the fuel tank. Make sure cap is tightened
securely. DO NOT over fi ll.

Fuel Tank

2.

— Capacity is 2.5 quarts (2.4 liters) of diesel

fuel.

Air Cleaner

3.

— Prevents dirt and other debris from

entering the fuel system. Remove wing-nut on top of
air fi lter canister to gain access to fi lter element.

DANGER

Adding fuel to the tank should be done
only when the engine is stopped and has
had an opportunity to cool down. In the
event of a fuel spill, DO NOT attempt to
start the engine until the fuel residue has
been completely wiped up and the area
surrounding the engine is dry.

NOTICE

Operating the engine without an air filter, with a
damaged air fi lter, or a fi lter in need of replacement
will allow dirt to enter the engine, causing rapid engine
wear.

Muffl er

4.

— Used to reduce noise and emissions.

Recoil Starting Handle (pull rope)

5.

— Type of engine

starting method.

Recoil Starter

6.

— Manual-starting method. Pull the

starter grip until resistance is felt, then pull briskly and
smoothly.

Oil Filler Cap / Dipstick

7.

— Remove this cap to add oil

to the engine crankcase. Read dipstick to determine if
oil level is low. DO NOT over fi ll.

Oil Drain Plug

8.

— Unscrew plug to drain oil from engine

crankcase. Dispose of oil in a safe manner.

Decompression Lever

9.

— Press down before starting

engine. To prevent damage to engine, DO NOT use for
any other purpose.

Fuel Cock

10.

— Controls the fl ow of diesel fuel to the

carburetor. Must be in the ON position when starting
and running the engine.

Speed Control Lever

11.

— Regulates engine speed.

WARNING

Engine components can generate extreme
heat. To prevent burns, DO NOT touch
these areas while the engine is running
or immediately after operating. NEVER
operate the engine with the muffler
removed.