MTS Multipurpose Simulated User Manual
Mts testsuite, Multipurpose simulated testing user guide
Table of contents
Document Outline
- 1.0 Technical Support
- 2.0 Preface
- 3.0 Controller Simulation Overview
- 4.0 Install Simulation Software
- 5.0 Running Simulation Tests
- 5.1.0 Simulated Controller Startup
- 5.2.0 Run Simulated Toughness Test
- 5.3.0 Run Simulated FCG Compliance Test
- 5.3.1.0 Open The Test
- 5.3.2.0 Define the FGC Compliance Test Parameters
- 5.3.2.1.0 Test Parameters Overview
- 5.3.2.2.0 FCG Compliance Parameter Values for Simulation
- 5.3.2.3.0 Precrack Parameters
- 5.3.2.4.0 Crack Growth Parameters
- 5.3.2.5.0 Delta K Control Mode Parameters
- 5.3.2.6.0 Constant Load Control Mode Parameters
- 5.3.2.7.0 Data Storage Parameters Properties
- 5.3.2.8.0 Test Termination Parameters
- 5.3.2.9.0 Assign Precrack Values
- 5.3.2.10.0 Calculator
- 5.3.3.0 Run the Test
- 5.3.4.0 View Test Results
- 5.3.5.0 Perform Data Analysis
- 5.4.0 Run the Simulated FCG DCPD Test
- 5.4.1.0 Open The Test
- 5.4.2.0 Set the FGC DCPD Test Parameters
- 5.4.2.1.0 Test Parameters Overview
- 5.4.2.2.0 FCG DCPD Parameter Values for Simulation
- 5.4.2.3.0 Precrack Parameters
- 5.4.2.4.0 Crack Growth Parameters
- 5.4.2.5.0 Delta K Control Mode Parameters
- 5.4.2.6.0 Constant Load Control Mode Parameters
- 5.4.2.7.0 Data Storage Parameters
- 5.4.2.8.0 Test Termination Parameters
- 5.4.2.9.0 Assign Precrack Values
- 5.4.2.10.0 Calculator
- 5.4.3.0 Run the Test
- 5.4.4.0 View Test Results
- 5.4.5.0 Perform Data Analysis
- 5.5.0 Run the Simulated JIC Fracture Toughness Test
- 5.5.1.0 Open The Test
- 5.5.2.0 Set the JIC Test Parameters
- 5.5.2.1.0 Test Parameters Overview
- 5.5.2.2.0 JIC Parameter Values for Simulation
- 5.5.2.3.0 Precrack Parameters
- 5.5.2.4.0 JIC Parameters
- 5.5.2.5.0 COD Mode Parameters
- 5.5.2.6.0 Displacement Mode Parameters
- 5.5.2.7.0 Data Storage Parameters
- 5.5.2.8.0 Test Termination Parameters
- 5.5.2.9.0 Assign Precrack Values
- 5.5.2.10.0 Calculator
- 5.5.3.0 Run the Test
- 5.5.4.0 View Test Results
- 5.5.5.0 Perform Data Analysis
- 5.6.0 Run the Simulated KIC Fracture Toughness Test
- Index