MTS Criterion 60 - Manual - Manual (Page 54)

MTS Criterion™ Series 60 Product Manual 54
Moving Frames and Integrated Operations Platform
Installation
3. Raise the hook slowly to lift the load frame only high enough to move.
4. Slowly and steadily move the load frame to the foundation.
5. Secure the load frame to the foundation; see “Securing the Load Unit” on
page 54.
Securing the Load Unit
To secure the load unit to the foundation:
1. Put the anchor bolts into the bolt holes. The top of the bolts should be lower
than the top of the foundation.
2. Align the anchor bolt holes on the load frame base with that of the
foundation, and slowly put down the load frame.
3. Put the anchor bolts, which are in the foundation anchor bolt holes, through
the load frame anchor bolt holes. Put the flat washers, spring washers, and
nuts on the bolts leaving 2-4 threads of the bolts on top of the nuts.
4. Center the anchor bolts and grout the anchor holes with cement mixtures.
Keep the anchor bolts at the center of the holes while grouting.
5. Grout the cement mixture to the same level of the groundwork and scrape it
level. After curing the foundation for a while, tighten the anchor bolt nuts.
Do not exceed 30
o
Supporting
Wood