MTS Multi-Pump Control Manager - Manual (Page 5)

Multi-Pump Control Manager Introduction
5
Introduction
The Multi-Pump Control Manager (MPCM) product family consists of a Basic
Connection Interface (BCI) and typically the optional dedicated PC running the
Supervisor software, with remote E-Stops, Station Flow Managers (SFM), and/or
light stacks as options. Together, these components allow you to remotely run
multiple HPUs similar to operation at the main HPU HMI panel.
This manual assumes you are familiar with local operation of the HPU. That is,
the descriptions of the controls and indicators that are similar to the controls and
indicators on the HPU will be abbreviated in this manual, and it is assumed that
you understand the full description provided in the HPU manual.
Note The Multi-Pump Control Manager and associated components can only
be used on the G2 HPU models. It will not work with the older HPU
models. Contact MTS for additional information.
In a typical configuration, there is one BCI, one Supervisor running on a
dedicated PC, up to eight large HPUs, and a combination of up to eight remote
E-Stops and SFMs. One or more optional light stack(s) can be included for HPU
status away from the control room.