MK Diamond MK-2000 - Manual (Page 25)

MK-2000 Revision 03/05, Effective Date March 21, 2005 Page 25
MAINTENANCE AND TROUBLESHOOTING
MAINTENANCE:
1. New Maintenance:
Perform the following after initial purchase and operation of the MK-2000.
2. Maintenance Following Use:
To extend the life of the MK-2000, the following procedure should be performed after each use. Lubricate all
points listed below with light oils such as, 3 in 1, WD-40, etc.
(C)
Lubricate the Movable Cutting
Table Roller Wheels
(D)
Lubricate the Blade Guard
Pivot Points
Inspect
V-belt
(A)
Check and adjust V-belt tension
following the first 48 hours of
operation (See V-belt Inspection)
(B)
Unplug the MK-2000 Polarized
plug from the power source by
turning counter-clockwise and
then pulling straight back
(A)
Ensure the ON/OFF Switch is
in the OFF position
ON/OFF
Switch
OFF
Position
Turn counter-
clockwise to unlock
Pull straight
back
Roller Wheel
(E)
Lubricate the Cutting Head
Pivot Points
Pivot Point
Pivot Point