MK Diamond MK-2000 - Manual (Page 23)

MK-2000 Revision 03/05, Effective Date March 21, 2005 Page 23
SETUP, ADJUSTMENT and OPERATION
5. Cleanup:
NOTES: 1. If an external water source was used, steps A through C may be skipped.
2. Dispose of wastewater in accordance with applicable Federal, State and Local laws.
Ensure the saw is disconnected before completing the remainder of the cleanup process.
(E)
Unplug the MK-2000 Polarized
plug from the power source by
turning counter-clockwise and
then pulling straight back
(B)
Place the Water Pump in an
external container
(A)
Clean the Water Pump suction
of all debris
(C)
Run the MK-2000 until clear
water is seen at the Blade
cooling ports (Approx. 1 minute)
Pump
Suction
(J)
Repeat steps H and I until
cutting is complete
Continue Steps
"H" and "I" to
complete cut
(K)
Turn the Saw off when cutting
is complete
ON/OFF
Switch
OFF
Position
Water Pump
in container
External Water
Container
Cooling Flow
Points
(D)
Ensure the ON/OFF Switch is
in the OFF position
ON/OFF
Switch
OFF
Position
Turn counter-
clockwise to unlock
Pull straight
back
(F)
Clean the MK-2000 with soap
and clean water
Soap and
Fresh Water