MK Diamond MK-2000 - Manual (Page 20)

MK-2000 Revision 03/05, Effective Date March 21, 2005 Page 20
SETUP, ADJUSTMENT and OPERATION
Cut in smooth even strokes; do not force the saw to cut.
3. Cutting with the Cutting Head Locked Down:
This method is preferred when cutting small objects.
Cut in smooth even strokes; do not force the saw to cut.
Note: Skip steps H and I, if cutting dry.
(I)
Continue lowering the Cutting
Head until the cut is complete
raise the cutting head when
the cut is complete
(H)
Lower the Cutting Head to
begin the cut
(G)
Position the Masonry Piece
below the Blade
Continue to Lower
Cutting Head until
Cut Complete
Position Masonry
Piece below Blade
Hold Masonry
Stationery
Lower
Smoothly
to Cut
(J)
Turn the Saw off when cutting
is complete
ON/OFF
Switch
OFF
Position
(A)
If locked, loosen the Cutting
Head Locking Handle
Locking Handle
Turn counter-
clockwise to loosen
(B)
Lower the Cutting Head until the
Blade touches the Protective
Wooden Strip
Lower Cutting
Head
(C)
Lock the Cutting Head in the
"Down" position using the
Locking Handle
Locking Handle
Turn clockwise
to tighten