MK Diamond MK-2000 - Manual (Page 13)

MK-2000 Revision 03/05, Effective Date March 21, 2005 Page 13
UNPACKING, TRANSPORT, UNIVERSAL STAND and ASSEMBLY
ASSEMBLY:
Follow the assembly instructions in this section to prepare your MK-2000 for operation.
1. Releasing Cutting Head:
The following actions will cause the Cutting Head to rotate upward, hold the saw by the handle and
control the upward movement.
NOTE: The Cutting Head is locked in the down position when shipped from the factory.
2. Movable Cutting Table Installation:
3. Adjustable Cutting Guide Installation:
NOTE: The Adjustable Cutting Guide can be used on either side of the Diamond Blade.
(C)
Verify Movable Cutting Table is
seated correctly
(B)
Seat Movable Cutting Table
Roller Wheels on Saw Guide
Rails
(A)
While holding the front, position
Movable Cutting Table Roller
Wheels above Guide Rails
(A)
Loosen Adjustable Cutting
Guide retaining thumbscrew
Cutting Table Front
Align
Parallel Slots
Ruler/Stop
Turn clockwise
to tighten
Seated
Roller Wheels Guide Rail Guide Rails Roller Wheels
Move back and forth to
verify ease of movement
(B)
Position Adjustable Cutting
Guide above Movable Cutting
Table
(C)
Seat and tighten the Adjustable
Cutting Guide retaining
thumbscrew
Turn counter-
clockwise to loosen
(C)
Install Locking Handle through
the Cutting Head Adjusting
Bar and into the Height
Adjustment Stud
(B)
Remove Shipping Bolt from the
Cutting Head – discard
Shipping Bolt
(A)
Remove Cutting Head Locking
Handle from shipping location
discard the Shipping Nut
Locking Handle
9/16-inch
wrench Shipping Bolt
Turn counter-
clockwise to
loosen
9/16-inch
wrench
Height
Adjusting Bar
Locking Handle
Turn clockwise
to tighten