Memmert ICH C (with CO2 control) Climate chambers - Manual (Page 50)

50 D30393 | Date 10/2014
Menu mode
If humidity/room temperature are particularly high, it is possible that the factory setting for
defrosting, 12 hours, is not sufficient. If this is the case, you should set a more frequent de-
frosting interval, e.g. every 6 hours.
Automatic defrosting is disabled with the setting
Off . When operating at low temperatures,
this over time causes the cooling unit to ice over. Regular defrosting needs to be carried out in
order to prevent damage to the cooling system.
7.3.7 Remote control
In the setup entry Remote control , you can set whether the
appliance should be controlled via remote control and if so,
in which mode. These settings are available:
► Off
► Read Only
► Write
► Write+Alarm
When the appliance is in remote control mode, the
symbol appears in the temperature display. In the symbol appears in the temperature display. In the
settings Write and Write+Alarm , the appliance cannot be
controlled at the ControlCOCKPIT until the remote control
has been switched off (setting Off) or set to Read Only .
In order to use the remote control function, program-
ming skills and special libraries are required.
7.3.8 Gateway
The setup entry Gateway is used to connect two networks Gateway Gateway
with different protocols.
The gateway is set the same way as the IP address (see page
47).
7.4 Date and Time
In the Time display, you can set date and time, time zone and daylight saving time.
Always set the time zone (and summer time yes/no) before you set the date and time.
Avoid changing the set time after that since this can lead to gaps or overlapping when
recording measured values. If you still need to change the time, you should not run a
programme immediately before or after doing so.
1. Activate the time setting. To do so, press
the activation key on the right side of
the Time display. The display is enlarged
and the first adjustment option ( Date )
automatically highlighted.
UFP 100
Date and time
Time
Time zone
Daylight savings
12 . 05 . 2012
12:00
GMT +1
SETUP
SOUND
CALIBRATION
LANGUAGE
SETUP
SOUND
CALIBRATION
LANGUAGE
Date
Setup
Balance
Remote Control Off
Gateway 192.168.5 .1
+30 %
2/2
23
.2°C
TEMP
Set 180
.0°C
Setup
Balance
Remote Control Off
Gateway 192.168.5 .1
+30 %
2/2