Memmert ICH C (with CO2 control) Climate chambers - Manual (Page 12)

12 D30393 | Date 10/2014
Construction and description
2.5.2 Communication interfaces
The communication interfaces are intended for appliances which meet the requirements of
IEC 60950-1.
USB interface
The appliance is fitted by default with a USB
interface in accordance with the USB specifica-
tion. This way, you can
►
transfer software stored on a USB storage
medium to the appliance (see page 56).
►
export protocol logs from the appliance to
a USB storage medium (see page 60).
►
transfer user ID data stored on a USB stor-
age medium to the appliance (see page
61).
The USB port is located on the right side of the ControlCOCKPIT (Fig. 3).
Ethernet interface
Via Ethernet interface, the appliance can be
connected
to a network, so that you can transfer pro-
grammes created with the AtmoCONTROL soft-
ware to the appliance and read out protocols.
The Ethernet interface is located on the rear of
the appliance (Fig. 4).
For identification purposes, each appliance con-
nected must have its own unique IP address.
Setting the IP address is described on page
47 .
You will find a description of how to transfer programmes via Ethernet in the en-
closed AtmoCONTROL manual.
With an optional USB to Ethernet converter, the appliance can be directly connected to a com-
puter / laptop (see Optional accessories on page 15).
2.6 Designation (nameplate)
The nameplate (Fig. 5) provides information about the appliance model, manufacturer and
technical data. It is attached to the front of the appliance, on the right behind the door (see
page 10).
Fig. 3 USB interface
Fig. 4 Ethernet interface