Lenze E94AxHE Technology Application Table positioning - Manual (Page 26)

9400 Technology applications | Table positioning
Parameter setting & configuration
Profile data management
26
L
EDS94TA10050xxxx EN 1.2 - 03/2010
5.4.6 "Teach" function
The "Teach" function of the profile data management enables the teaching of positions,
speeds, accelerations and S-ramp times.
The basic function "Manual jog" serves, for instance to approach the desired position
manually and transmits it via "Teaching" to the variable table for positions.
 Parameter setting: Tab Application parameters  dialog level Overview 
L_PositionerTable
Control/setpoint inputs of the function Signal configuration
Lenze setting Control/setpoint input (Multiplexer parameters)
FALSE  Teach position C03020/1
C03016  Selection of table position for position C03029/1
Zero position  Teach position C03125/1
FALSE  Teach speed C03020/2
C03017  Selection of table position for speed C03029/2
Speed setpoint  Teach speed C03024/1
FALSE  Teach acceleration C03020/3
C03018  Selection of table position for acceleration C03029/3
0  Teach acceleration C03027
FALSE  Teach S-ramp time C03020/4
C03019  Selection of table position for S-ramp time C03029/4
0  Teach S-ramp time C03028

Note!
After the function block editor is enabled the "Teach" function must be
configured directly in the FB interconnection instead of via the parameters
mentioned before!