1 about this documentation, About this documentation, 1about this documentation – Lenze E70ACxS Application Sample i700 (PLC Designer v3) User Manual
Page 3

Lenze · Servo Inverter i700 | Application Sample · DMS 1.0 EN - 09/2012 - TD11
3
About this documentation
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
1
About this documentation
This documentation describes the sample project for the i700 servo inverter for commissioning a
Lenze automation system. The used automation system consists of a PLC for "Controller-based
Automation" and drive components connected (via a bus system).
The explanation of the procedure includes the installation of the integrated development
environment, the »PLC Designer«, and the diagnostics of the application.
Tip!
Information and tools regarding the Lenze products can be found in the download area at:
http://www.Lenze.com
This manual is part of the Controller-based Automation manual collection. The manual collection
consists of the following parts:
Read the Mounting Instructions accompanying the controller first before you
start working!
The mounting instructions contain safety instructions that must be observed!
Note!
This documentation supplements the software manuals of the »PLC Designer« and »PLC
Designer«.
Documentation
Subject
System manuals
• Controller-based Automation - System structure & configuration
• Visualisation - System structure & configuration
(Software) manual
• Controller - Parameter setting & configuration
Communication manuals
• Controller-based Automation EtherCAT - Commissioning & configuration
• Controller-based Automation CANopen - Commissioning & configuration
• Controller-based Automation PROFIBUS - Commissioning & configuration
Further software manuals
• »PLC Designer«
• »Engineer«
• »Global Drive Control« (»GDC«)
• L-force Controller as gateway - Parameter setting & configuration
• »VisiWinNET® Smart«
• »Backup & Restore«
Information on the use of the controller beyond the field of "Controller-based
Automation" can be found in the system manuals tailored to the application
case.