Lenze E70ACxS Application Sample i700 (PLC Designer v3) - Manual (Page 10)

Preconditions
Setting up communication to the Controller
10
Lenze · Servo Inverter i700 | Application Sample · DMS 1.0 EN - 09/2012 - TD11
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
• Enter the desired IP address of the Controller.
[3-1] Example: Enter the IP address of the Controller
3. Click OK to add the Controller as gateway.
4. By double-clicking the desired channel (or clicking the Set active path button) set the
channel selected in the Device View below the gateway as active path for control.
• Thus, all communication actions directly refer to this channel.
• The currently active path is represented in bold in the list and "(active)" is attached:
5. A device represented in italics is set as active path but has not been identified during the
last network scan.

Note!
• During initial commissioning, observe the following predefined IP addresses of the
Controllers: 192.168.5.99

Further information can be found in the following documentation:
• Controller - Parameter setting & Configuration