Lenze E84DGFCG - Manual (Page 85)

Error messages
Possible causes and remedies
85
Lenze · Decentralised frequency inverter 8400 motec (EtherNet/IP™ option) · EDS84DMOTEIP EN 2.0 - 10/2013
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
EtherNet/IP: Idle Mode [0x01bc8132] (nt05: COM fault 5)
EtherNet/IP: Duplicate IP Address [0x01bc8273]
Response (Lenze setting printed in bold) Setting: C13880/1
 None  System error  Error  Fault  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
• Scanner has received an idle event.
• The scanner is in the "PROG" mode.
• In the "Scanner Command Register", the run/
idle flag (bit 0) is 0.
Set the scanner to the run mode.
Run/idle flag (bit 0) = 1
Response (Lenze setting printed in bold) Setting: not possible
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
An IP address has been allocated twice within the
network. The addresses of the network nodes must differ
from each other.
Correct the IP address ( C13000 ).
 Setting the IP configuration of the Inverter Drive 8400
motec ( 30)