Leica Biosystems VT1000 P - Manual (Page 7)

7 Leica VT1000 P
2. Safety
Warnings – Markings on the instrument itself
• Warning labels on the instrument marked with a warning triangle indicate that the correct
operating instructions (as defined in this Operating Manual) must be followed when operating
or replacing the item marked. Failure to adhere to these instructions may result in an accident,
personal injury, damage to the instrument or accessory equipment.
• Observe the warning messages on the rear side of the instrument ( Fig. 2 ).
Only the components described in the section on " Replacing components " may be replaced by
the operator.
Warnings – Transport and installation
• Once unpacked, the instrument may be transported only in an upright position.
• Never lift or transport the instrument by holding it by the blade holder or setting wheel for the
section thickness.
• The instrument must be set up so that the main power switch on the left rear side of the instrument
( item 14 in Fig. 2 ) is easily accessible at any time.
Fig. 2
4
Warnings – Maintenance and cleaning
• The instrument may be opened by authorized service personnel only.
• Always disconnect the power plug before opening the instrument!
• Turn the instrument off using the power switch and disconnect the power plug before replacing
the fuses. The use of fuses other than those provided is not permitted.
• Before each cleaning, remove the disposable blade or knife!
• Do not use any solvents containing acetone or xylene for cleaning! Ensure that liquids do not
enter the interior of the instrument during cleaning.
• Do not clean the magnifier using cleaners that contain solvents, as the lens is made of acrylic.
• When using detergents, please comply with the safety precautions of the manufacturer and the
laboratory regulations!
15