Landoll ICON 414 - Manual (Page 5)

ICON Industries Commercial Earthmover
Assembly, Lube and Check List
____1. Install cutting bits, Torque retaining bolts.
____2. Locate and pin rear lift assembly. Install lift
cylinders. Torque all retaining bolts.
____3. Position and pin eject wall. Install eject
cylinder and linkage. On Series D Models
pin the floor and install cylinder.
Torque all retaining bolts. Install the depth gauge components.
____4. Locate and pin front gate and gate lift assembly.
Install lift cylinder. Torque all retaining bolts.
____5. Install front swivel hitch assembly. Torque all retaining bolts.
____6. Install axle and wheel components. Torque all retaining bolts.
Inflate tires to required PSI.
____7. Locate and assemble all hydraulic fittings, hoses and pipes. If
applicable, install tandem option package. Install front hose
holder assembly. Properly tighten fittings, taking care not to
overtighten. Install the proper markings to each hose and apply color coded hose wrap.
____8. Install safety lighting components, route wiring and install plug
retainer. Cycle and check lighting system with 12 volt system
tester.
____9. Lubricate all moving components with high temperature grease.
___10. Fill hydraulic systems with Mobil 424 hydraulic oil. Using
hydraulic pump, activate all moving parts and bleed air from the
system. Hold 3000 PSI hydraulic pressure against all cylinders,
fittings, and hoses for a minimum of 4 minutes. Check all
components for leaks.
___11. If the optional brake assembly is installed, check and cycle
brakes, bleed air if necessary.
___12. Calibrate the depth gauge.
Clean and touch up paint the machine. Attach manual/container.
Make sure each hyd. accumulator is charged to (650psi. on 800 series, 350psi on 18D’s)
___13. Apply the serial tag, operations, lube and identification decals.
Attach ICON check list to the front of the machine. Warranty
info and Dealer 36 hr. check list is located in the manual.
___14. Check safety stops to be sure that each properly engage and
lock the components in a safe and secure manner.
ICON Supervisor Signature: All of the above listed assembly and check
functions have been completed per my rigid standards.
____________________________________________________
Serial #______________ Checked By
Date_________________ __________________________________
Supervisor
Swivel Hitch Stamp____________________________
Owner’s Copy