Landoll ICON 414 User Manual
Page 17

Back the power unit into position, attach the hydraulic
lines.
Pull the snap pin and slide the lock down pin out, allowing
the lock down ears to pivot forward.
(shown in the adjoining photo)
Position the swivel hitch above the quick hitch, and
hydraulically lower it into the cradle of the quick hitch.
Pivot the lock down ears over the adapter and replace
the
lock down pin and snap pin.
Valve #1 should be placed in
the #1 outlet (raise/lower) # 2 should control the gate/wall.
NOTE: The ICON hitch is designed for safety, and one man operation — However, as with any moving part, the
potential for injury is present. Be aware of your surroundings while backing. Make certain no one is between the
scraper and the tractor while backing. Keep hands, feet and all body parts away from any machine component
that pivots, swings, or moves in any way, to avoid a potential injury.
If the machines are being pulled as a tandem unit, Valve
#3
should control the gate/wall of the tandem machine and Valve
#4 should control the raise/lower of the tandem
machine.
This hook up is only recommended, the operator should
adjust
for
his/her own convenience.
Shown below is the current hydraulic configuration of the 800 Series Challenger. The covers are marked with a + or -, and the
ICON hoses are marked accordingly. Also the optional brake hook up is shown
.
NOTE: High Pressure fluid can cause serious damage to eyes and hands. See Safety Section for safe hookup procedures.
2000519 complete
Lock Down Pin
Lock Down Ears
snap pin