Landoll 2510 Series In-Row Ripper - Manual (Page 23)

ASSEMBLY INSTRUCTIONS
3-9
Figure 3-6: Harness Wire Designations
Electrical Installation
NOTE
See Figures 2-1 - 2-3 for light bracket placement.
1. Attach left and right light brackets with reflectors to
frame using warning light bar, 1/2-13 x 7-1/2 hex
head cap screws and hex lock nuts (See Figure 3-5.)
2. Attach ag amber single LED lamps to light brackets
using 1/4-20 x 1-1/4 hex head cap screws and hex
lock nuts.
3. Attach left tail light mount to frame assembly using
u-bolt and 5/8-11 flange head serrated nuts.
4. Attach right tail light mount and ag flasher control
module to frame assembly using u-bolt and 5/8-11
flange head serrated nuts. Be sure that the control
module is set so that the 4 pin connector faces the
right side of the machine.
5. Attach reflector assemblies and ag red single LED
lamps to tail light mounts using 1/4-20 x 1-1/2 hex
head cap screws and hex lock nuts.
IMPORTANT
Make sure lights are positioned for maximum
visibility from the rear.
6. Install the LED warning light harness to the frame.
Connect 2 pin and 3 pin ends to each of the warning
lights. Connect 6 pin to the ag flasher control module.
7. Attach 7 pin/4pin 120” harness to frame. Connect 4
pin end to the ag flasher control module.
8. Insure that the harnesses are clear of any moving
parts and secure the harnesses with tie wraps
provided.
9. Install the stor-away holder bracket on bolt in coulter
clamp plate and assemble harness stor-away to
bracket with 1/4-20 x 3/4 hex head cap screws and
hex lock nuts.
7-PIN
CONN
1
2
3
4
5
6
7
D
B
A
C
GROUND
WORK LAMPS
LEFT FLASHING
& TURN
STOP LAMPS
RIGHT FLASHING
& TURN
TAIL LAMPS
SWITCHED
POWER (12V)
4-PIN
TOWER
GROUND
BLACK
YELLOW
RED
GREEN
BROWN
BLUE
CIRCUIT WIRE
COLOR
BLACK
LEFT TURN
WHITE
GROUND
BROWN
TAIL
YELLOW
LEFT TURN
GREEN
RIGHT
RED
RIGHT
A
B
C
D
E
F
2-PIN
TOWER
1 2 3 4 5
3-PIN
TOWER
6-PIN
SHROUD
3-PIN
TOWER
2-PIN
TOWER
A
B
A
B
C
C
A
B
A
B
m2510 harness wire designations
7 PIN/4 PIN 120” HARNESS
LED WARNING LIGHT HARNESS