Landoll 2510 Series In-Row Ripper - Manual (Page 19)

ASSEMBLY INSTRUCTIONS
3-5
Figure 3-3: RSB Clamp and Straight Shank Assembly
RSB Clamp and Straight Shank
Assembly
1. The rigid clamp assemblies are already located on
the frame at the proper spacing.
2. Attach wearstrip to straight leg shank using wearstrip
bracket, 3/4-10 x 3 hex head cap screw, and 3/4-10
hex lock nut (See Figure 3-3.)
3. Attach steel point to straight leg shank using 1/2 x 2
and 5/16 x 2 spring slotted pins. Place pins with open
ends oriented opposite of each other.
4. Attach top of shank point assembly to front of spring
clamp assembly using 3/4-10 x 4 hex head cap
screw and hex lock nut. Attach lower hole of shank
point assembly to rear of spring clamp assembly
using 5/8-11 x 3-3/4 hex head cap screw, connex
bushing, and 5/8-11 hex lock nut.
5/8-11 X 5-1/2 HEX
HEAD CAP SCREW
3/4-10 X 4 HEX
HEAD CAP SCREW
RIGID CLAMP
ASSEMBLY
3/4-10 X HEX
LOCK NUT
5/8-11 HEX
LOCK NUT
SHANK POINT
ASSEMBLY
SEE DETAIL A
m179965 op
DETAIL A
3/4-10 HEX
LOCK NUT
5/8-11 HEX
LOCK NUT
WEARSTRIP
BRACKET
WEARSTRIP
1/2 X 2 SPRING
SLOTTED PIN
CONNEX
BUSHING
3/4-10 X 4
HEX HEAD
CAP SCREW
3/4-10 X 3
HEX HEAD
CAP SCREW
5/8-11 X 5-1/2
HEX HEAD
CAP SCREW
5/16 X 2 SPRING
SLOTTED PIN
POINT PIN
PLACEMENT