Landoll 2510 Series In-Row Ripper - Manual (Page 21)

ASSEMBLY INSTRUCTIONS
3-7
Coulter Assembly
1. Assemble coulter shank to coulter assembly using
coulter stop weldment and 5/8-11 x 1-1/2 square
head set screw. Install 3/8 x 2 spring slotted pins in
coulter shank.
2. Install the shank and coulter assembly to the frame
with the coulter clamps and plates using 1/2-13 x 6
hex head cap screws and hex lock washers (See
Figure 3-4.)
3. Use square head cup point set screws through hole
in clamp to hold coulter shank in place.
4. Attach the coulter blade to the coulter assembly
using 1/2-13 x 1-1/2 round head square neck screws,
hex lock washers, and hex nuts.