Landoll 2510 Zone Commander - Manual (Page 32)

4-4 F-758-R0
MAINTENANCE
Trouble Shooting
The Troubleshooting Guide, shown below, is included to
help you quickly locate problems that can happen using
your Zone Commander. Follow all safety precautions
stated in the previous sections when making any
adjustments to your machine.
PROBLEM PROBABLE CAUSE SOLUTION
SPIKES DO NOT
PENETRATE TO DESIRED
DEPTH Coulters set too deep Adjust coulters up, to just run in firm
soil, to cut residue.
Spikes worn back Replaces spikes
Lower hitch arms in lower holes of pull
bracket Move hitch arms to upper hole in pull
brackets.
Implement not level Adjust top 3-point link.
UNIT BOUNCES OR NOT
WORKING AT UNIFORM
DEPTH Gauge wheels not set at correct depth Adjust gauge wheels to correct depth.
NOTE
Gauge wheels, not the 3-point hitch,
should carry the load.
Gauge wheels not set at correct depth Adjust all gauge wheels to same depth.
Tire pressure not equal Inflate all tires to the same pressure.
Lower hitch arms not set to same
height Measure lower hitch arms and adjust to
uniform length.
RESIDUE HANGS ON
SHANKS Coulter not set deep enough Adjust coulter down to run in firm soil,
to cut residue.
Gauge wheel too close to shank Position gauge wheel on frame for
maximum clearance to shanks.
Coulter not aligned Check coulter alignment on front bar.
Soil too wet causing hairpinning of
residue Let soil dry.