beautypg.com

Landoll XO108/XO108-1 X-Fold Pulverizer User Manual

Page 29

background image

LED Lamp and Harness Installation

1. Install each Light Bracket to the rear frame tube, approximately 25” from the center of the

frame, making sure there is sufficient clearance between the bracket and raised tire. Secure

with 5/8-11 U-Bolts and Nuts, ensure U-Bolts are not interfering with raised wheel arm
tube. See page 17B.

2. Install the Light Module under the Module Bracket using two 1/4-20 X 1-1/2” Screws and

Locknuts. See page 17B. Attach the Module Bracket to the front frame tube left of center, using
two 3/8-16 U-Bolts and Nuts. See pages 17B and 17C.


3. Attach the 7 pin harness to the Light Module. Route the harness along the frame and drawbar

with the hydraulic hoses. See page 17C.


4. Layout the LED Lamp Harness. Note that the cords are marked “Left” and “Right”.

Attach the harness to the Light Module.

5. Route the left 3 plug cord along the left side of the frame center tube, across the rear frame

tube, then under and through the Left Tail Light Mount.

6. Route the right 3 plug cord

along the right side of the front frame tube

and along the inside

of the inner frame tube, then under and through the Right Tail Light Mount.

7. Route the remaining left and right 2 plug cords along the left and right front frame tube. Route a

2 plug cord end into the bottom of each Lamp Bracket until the end sticks out the top. See page
17C.


8. Plug a 2 plug harness end into each Amber LED Lamp. Attach Amber LED Lamp to the light

bracket with 1/4-20 X 1-1/2 Screws and Locknuts. Attach the left Lamp Bracket to the back of
the front frame tube and the right Lamp Bracket to the front of the front frame tube using 1/2-13
U-Bolts, Flat Washers and Locknuts. See page 17C.

9. Plug a 3 plug harness end into each Red LED Lamp. With the lens facing rearward, install a Red

LED Lamp onto each Tail Light Mount using 1/4-20 X 1-1/2 Screws and Locknuts. See page
17C.

10. Secure both harnesses with tie straps, making sure to leave enough slack, where the drawbar

meets the frame, to allow the machine to raise and lower. Secure LED lamp harness molded
union to module bracket using Tie Straps. Bundle and secure any excess cord with tie straps.
See page 17C.

11. Raise, lower, fold and unfold machine to check for proper clearance, adjust accordingly.

683rev1113

17D

6J862

with 3/8 Bolt and Nut. Attach the Tail Light Mounts to the ends of the rear frame and secure

NOTE: Connectors marked with Green Tape is Right Side and Yellow Tape is Left Side.