Landoll XO108/XO108-1 X-Fold Pulverizer - Manual (Page 16)

6J862 683rev501 Page 10B
OPTIMIZER WHEEL
PLACEMENT
19’
- 27’
Wide Models with
20”
Optimizer
Wheels - 4 1/2” bore
(6K353 Wheel & 6K354 EndWheel)
“XO” Models
CENTER SECTION
(16 Wheels, 2 End Wheels)
WING ASSEMBL
Y/side:
5’=
8 Wheels, 2 End Wheels
6’=10 Wheels, 2 End Wheels 7’=12 Wheels, 2 End Wheels 8’=14 Wheels, 2 End Wheels 9’=16 Wheels, 2 End Wheels
Position W
elded Ring on
Axle to inside
Male & female ends must mate and remain in close contact.
5’
Wing - 65 1/2”
Position Axle Clamp to outside
Position Axle Clamp to outside
9’
Wing - 1
13 1/2”
6K353 Optimizer Wheel
The above diagram shows wheel gang positioning and assembly
for the center and wings of optimizer model pulver-
izers
using
optimizer
wheels.
When
assembling,
position
the
axle
clamps
toward
the
outside
end
of
the
wing
and
the
machine.
Also,
it is especially important that
fi
t of wheel on the shaft remains tight. W
ear and damage can
result from wheels that do not
fi
t tightly against one another
. Make frequent checks to insure that close
fi
t
remains intact. If wheels have jostled apart, adjustment is made by loosening and moving the clamp until the wheels are tightly in place. Then retighten clamp.